Combi 6 E is a warm air heater with integrated hot water generator. It’s different from Combi 6 due to its integrated electric heating elements. These allow you to run the heater in gas, electrical or mixed mode. For stationary use at camp sites, you can run the Combi heater with the 12V power supply unit without the vehicle battery.
*ducting and outlets sold separately*
With integrated heating rods: Runs in gas, electric or mixed mode
Fast and even water heating in a short time
Extremely low power consumption
Energy sources: Propane / butane + electricity
Operating pressure: 30 mbar
Rated heat output in gas mode: 2000 W / 4000 W / 6000 W
Rated heat output in gas mode: 900 W / 1800 W
Rated heat output in mixed mode: max. 6900 W
Fuel consumption: 160 - 460 g/h
Power consumption (at 12 V): operation of heater and water container: max. 6.5 A for short periods (average approx. 1.4 A)
Power consumption (at 12 V): heating water container: max. 0,4 A
Power consumption (at 230 V): 3.9 A / 7.8 A
Air flow rate (free blowing) with 4 warm air outlets: max. 287 m3/h
Quiescent current: approx. 1mA
Quiescent current consumption CP plus (optional): 3 mA
FrostControl heating element (optional): max. 0,4 A
Water capacity: 10 litres
Pump pressure: max. 2,8 bar
System pressure: max. 4,5 bar
Heating time (from approx. 15 C to approx. 60 C): Water container: approx. 23 minutes
Heating time (from approx. 15 C to approx. 60 C): Heater and water container acc. to EN 15033: approx. 80 minutes
Weight: approx. 15.5 kg
Dimensions (L x W x H): 510x450x300mm
installation dimensions (min.imum dimensions-additional space must be provided for the gas connection. water connections and drain valve (L x W x H) depending on the installation situation): 540 x 500 x 350 mm
Heater (without waste gas discharge) complete with room thermostat, control panel with 6m cable, fastening parts, current-free frost control safety/drain valve and elbow fitting for 10mm water hoses.
There are currently no documents available for this product.
